Summit Arts Design Production LTD
INSTALLATION INSTRUCTIONS
Reversing the door orientation
The default left side orientation of the glass door can be changed to the right side. Use the following
procedure to change the side of the door hinge.
• Turn the temperature knob to the 0 position and disconnect the power plug from the wall outlet.
• Tilt the cooler backwards to an angle of 45
• Remove the bigger adjustable foot from the base (only for GPC1088).
• Loosen the screws on the base of the cooler and remove the bottom hinge.
• Place the bottom hinge on the opposite side and retighten it with screws.
• Reinstall the bigger adjustable foot. Make sure that it is installed on the opposite side (only for
GPC1088).
• Place the cooler back to the upright position.
• Remove the door hinge cap.
• Loosen the screws and remove the door hinge.
• Place the door hinge on the opposite side and retighten it with screws.
• Make sure that the glass door is in the vertical position and can be closed easily.
• Reinstall the hinge cap.
Note: After reversing the door hinge, the door gasket may get loose. Should you
notice a gap between the gasket and the cabinet, gently pull it out to seal the gap.
A correct gasket positioning is the key to prevent refrigerated air from escaping.
Ideas for saving energy
• Locate the product in the coolest part of the room, out of direct sunlight, and away
from sources of heat. If this is not possible, a section of cabinetry or an added
layer of insulation will help the cooler operate more efficiently.
• Level the cooler so that the door closes tightly.
• From time to time, adjust the temperature inside the refrigerator, since it changes
along with:
- the room temperature
- the frequency at which the refrigerator door is opened and how long it stays open
- the items inside
• Place the cooler at least 15cm away from walls or other articles.
• Do not cover the product's ventilation openings.
(IM)601-000229_MAKRO_GPC1046+GPC1088_Booklet-IM_V1_140317.indb 50
and securely support it.
0
50
Size: A5
GB
14/3/17 7:46 pm