ledscom LC-L-265 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, switch off the corresponding circuit
breaker of the house installation.
2. Remove the mounting plate (1) by
loosening the screws (2). Then carefully
lay the light on its side so that it cannot be
damaged.
3. Drill two holes in the mounting base and
place there if necessary. Dowel in. The
positioning of the holes should correspond
to those of the screw holes (3) on the
mounting plate. Make sure that the dowels
are flush with the substrate.
4. Poke a hole in the sealing ring (4) with a
knife or screwdriver. Guide the building-
side connection cable through this and
then fix the mounting plate (1) to the
mounting base with the aid of two screws.
Make sure that the arrow (5) points
upwards.
5. Connect the wires of the cable
according to "Figure 2". Place the luster
terminal in the receptacle (6) provided for
this purpose.
6. Place the light back on the mounting
plate (1). The water outlet (7) must point
downwards. Then retighten the screws (2)
to fix the light to the mounting plate.
7. Unscrew the two end pieces (8) of the
lamp counterclockwise and insert the bulbs
in the connection. Then hand-tighten the
end pieces. The installation is now
complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Mounting plate
2: Screws
3: Screw holes
4: Sealing ring
Figure 2
Wall lamp (LC-L-265) - Assembly instructions
5: Arrow
6: Recording
7: Water outlet
8: End pieces
04/2022