König Health Care HC-FA10 Manual De Uso página 3

All manuals and user guides at all-guides.com
Alarm Clock Settings
1. Press MODE button to select Alarm Clock Mode. When AL is lightened, press SET button for
2 seconds to start Alarm Clock settings. Press 5/° to turn on/off alarm clock function. If the
function is turned on, the LCD screen will display (It has a small bell and fi gures on the screen,
the AL is fl ickering.). If the function is off, the LCD screen will display (There is no small bell but
a fl ickering AL symbol on the screen).
2. When alarm clock function is on, press SET button and the Hour fi gure is blinking. Press SET
button again then the Minute fi gure is blinking. Press 5/° button to adjust the fi gure then press
SET button for confi rmation. Press MODE button to enter next mode.
3. If time is setup and the Alarm Clock function is turned on, it will beep to awake the user when it
arrives the setup time. It can automatically stop ringing after 1 minute.
Note: The beep won't stop if you press 5/° buttons at the same, this function can be used for sound
test.
All above settings of Clock, Personal information, Alarm Clock are stored by battery memory.
Hence, every setting need to be reset after battery replaced.
Battery Replacement
This product uses one CR2025/3V cell.
When install the cell, please pay attention to its anode and cathode side. (Put the side with
characters upwards)
When it is short of power please replace the cell promptly.
Please follow the instructions on the product's back.
About Error Information
The result shows error information, it may be caused by the following reasons
After pressing the measure button, fi ngers haven't been put on the correct places
Fingers are too dry.
Fingers have been put on the touch points but you didn't press hard enough.
Personal data beyond the product's effective range or incorrect data input
Maintenance and Attention
This product uses one CR2025/3V lithium cell. When it is short of power please replace the cell
promptly and pay attention to its anode and cathode side. (Put the "+" side upwards)
When the product doesn't display or cannot' display normally, please press the RESET button on
its back
Don't put it in high temperature surroundings or place it under direct sunshine
Please keep the product clean, don't put it into any liquid and keep it away from fi re.
Treat the product with care.
Do not disassemble this product by yourself
This product's measure result of fat content ratio and fat estimation is only a reference for one's
health management. If there is any doubt of the fi gure, it's better to get in touch with a doctor or
professional person.
Please put it away from children
This product is not suitable for pregnant women, pace maker users and people who have
implants.
3