Publicidad
Idiomas disponibles
Idiomas disponibles
HAWAII
Assembly option I, Fig.
Disconnect the pump from the solar station (remove plug).
●
Push the base from above onto the filter holder (snap lock).
●
Push the polystyrene float into the base from below.
●
Prevent the pump from floating away by attaching a stone to the anchor eye (below
●
the filter holder) with a piece of string.
Insert the plug into the socket (Fig.
●
Assembly option II, Fig.
Disconnect the pump from the solar station (remove plug).
●
Note: Depending on the depth of the pond, up to three extension pipes can be used
in order to make the jet potrude above the surface of the water.
The extension pipes and the three jet covers are located in the
magazine (Fig. c) of the filter body!
Press the base onto the filter holder from below (snap lock).
●
Submerge the base in the water.
●
Place suitable stones in the base as ballast.
●
Insert the plug into the socket (Fig.
●
OPERATION
1. Putting into operation / Priming the unit:
If your pump does not work at full capacity after connection to the pump solar
●
station, the pump must be primed. This is done by unplugging the pump from the
solar station and plugging in again several times (for approx. 3 secs. each time)
(Fig.
, arrow). The priming effect is greatest when operating without jets.
Remove one of the jets from the magazine
●
Mount the selected jet onto the base and push the jet with base into the pump.
●
Insert the plug into the socket (Fig.
●
2. Putting into operation / first charging
First operate the solar station for two days in direct sunlight or 24 hours with the
●
Wagner mains charging unit (accessory) in order to charge the rechargeable
battery. For this, the selection switch must be set to "0" (Fig.
3. Switch on "0":
For use when charging the battery with the Wagner mains charging unit (acces-
●
sory), and If the Solar Fountain Set is being transported or not used for long periods
of time (storage), turn the selection switch (Fig.
Set will no longer be operational.
Note: In order to protect the rechargeable battery and achieve longer performance
of the pump, especially in spring and autumn, we recommend recharging the
battery from time to time fully discharged. Set the solar station for the loading
time of the battery to position "0".
All manuals and user guides at all-guides.com
:
ö
, arrow) of the solar station.
:
, arrow) of the solar station.
, arrow) of the solar station.
) coarse spray, fine spray or single jet.
, arrow).
‚ arrow) to "0". The Solar Fountain
GB
11
Publicidad
