Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
■
Do not short-circuit the terminals of the appli-
ance or battery.
Operating instructions
Please observe the safety instructions for the re-
chargeable battery and the charger in the sepa-
rate operating instructions.
See:
■
Operating instructions 443130: Rechargeable
batteries
■
Operating instructions 443131: Chargers
3.6
Safety instructions relating to operation
■
During pruning, lift the pole-mounted pruner
to a maximum angle of 60°. At a steeper an-
gle, you inevitably get into the area where
cut-off branches can fall. Always stand out-
side this area.
■
Plan an escape route in advance for getting
out of the way of falling branches. This es-
cape route must be free of obstacles such as
sawn-off branches or slippery places that
could hinder getting out of the way.
■
Keep a safe distance from bystanders, ani-
mals, objects or buildings, which is at least
approx. 2.5x the length of the branch to be
sawn off. If that is not possible, saw the
branch off piece by piece.
■
Do not attempt to saw a branch that has a di-
ameter greater than the length of the chain
bar.
■
Avoid moving branches or objects becoming
caught in the saw chain. In this case, immedi-
ately switch off the pole-mounted pruner.
■
Remove the rechargeable battery from the
basic tool and push the protective cover over
the saw chain before:
■
Inspection, adjusting and cleaning work
■
Work on the chain bar and saw chain
■
Leaving the tool
■
Transport
■
Storage
■
Maintenance and repair work
■
Danger
■
Maintain a minimum distance of 10 m to
overhead electrical lines.
443176_a
4 INSTALLATION
WARNING! Danger if assembly is not
carried out completely! Use of an incompletely
assembled appliance can result in serious injury.
■
Operate the appliance only when it is fully as-
sembled!
■
Do not insert the battery into the appliance
until it is fully assembled!
CAUTION! Danger of laceration injuries.
The sharp edges of the saw chain can cause lac-
eration injuries when assembling.
■
Before installation, remove the rechargeable
battery.
■
Wear safety gloves when installing the saw
chain and the guide rail.
4.1
Fitting/removing the saw head (02)
Fitting the saw head
1. Align coupling (02/1) of the saw head and
telescopic pole (02/2) with one another so
that the embossed arrows are facing each
other.
2. Push coupling and telescopic pole completely
into one another (02/a).
3. Push locking sleeve (02/3) completely over
the coupling (02/b).
4. Turn the locking sleeve in the direction of
the closed padlock (02/c).
Removing the saw head
1. Turn the locking sleeve in the direction of
the open padlock.
2. Pull off the saw head.
5 START-UP
DANGER! Danger of fatal injury and dan-
ger of extremely severe injury. Lack of knowl-
edge of the safety instructions and operating in-
structions can lead to extremely serious and even
fatal injury.
■
Read and follow all the safety instructions
and instructions for use in these operating in-
structions as well the operating instructions
referred to before using the pole-mounted
pruner!
33
Publicidad
