1/ Description; 2/ Use Of The Room Thermostat; Waking Up The Screen; Setting Temperature Settings - DELTA DORE PACK DELTA 8000 BUS CO 1.1 Instrucciones De Uso

1/ Description

Defect in progress
Current mode
HEAT/COOL
button
HEAT/COOL button: appears only if your installation is reversible
thermostat is configured as 'Master' (
In OFF mode, press the button for 3 seconds to toggle between modes (HEAT:
heating/Cool: cooling). The screen will display the current mode.
MODE button: depending on the thermostat
the zone or the installation to off/on mode.
- 'Master' thermostat: press the button for 3 seconds to switch the system on or off.
- 'Zone' thermostat: briefly press the button to toggle the zone on or off (be careful,
if your installation is in general shutdown, you will not be able to toggle the zone on).
i key: by pressing it briefly in succession, you display the temperatures (setpoint or
measured) and any faults (see installation manual or contact your installer).
Output status: ON = the zone requests heat or cool (available according to
configuration - installation manual: CF04).
(1)
: heating/cooling.
(2)
: contact your installer or see installation instructions to configure your 'Master' or 'zone' thermostat:
CF05).
12
Locked mode
Off
Output status
Mode button
Information button
and the
(1)
2 ).
configuration, it allows you to switch
(2)

2/ Use of the room thermostat

2.1 Waking up the screen

The screen goes to 'Sleep' after a 10-second time-out
period.
To wake it up, press any button.

2.2 Setting temperature settings

Press + or - to set the value.
Press OK to confirm.

2.3 Locking down settings

Press and hold the 'i' button for 5 seconds.
The symbol appears.
Release.
In this mode:
- settings are deactivated,
- only the temperature display is authorised.
To unlock, press and hold the i button for 5 seconds.
EN
5 s
13