Eco-Friendly Disposal Of The Battery; Battery Charger; Charging Procedure - ST BT 520 Li 48 Manual De Instrucciones

agent or by specifically qualified personnel
in order to reduce any resulting risk.
4. ECO-FRIENDLY DISPOSAL
OF THE BATTERY
The following toxic and corrosive
materials are found within the battery
pack used with this tool: Lithium-ion is a
toxic material.
All toxic materials should be
disposed of properly to prevent
environmental contamination.
Before disposing of damaged or broken
lithium-ion battery packs, contact your
local waste disposal agency or the local
Environmental Protection Agency for
specific information and instructions.
Dispose of batteries in a certified lithium-
ion recycling and/or disposal facility.
If the battery pack cracks or breaks,
with or without chemical leakage, do
not recharge or use it. Dispose of and
replace it with a new battery pack.
DO NOT ATTEMPT TO REPAIR IT!
In order to avoid accidents and risks of
fire, explosion or electric shock and to
prevent damage to the environment:
– Cover the battery terminals
with strong adhesive tape.
– DO NOT attempt to remove or destroy
any part of the battery pack.
– DO NOT attempt to open the battery pack.
Electrolytes released from battery
pack chemical leakage are corrosive and
toxic. Do NOT allow chemical substances
to come into contact with eyes, skin
and, above all, do not ingest them.
– DO NOT dispose of batteries
with domestic waste.
– DO NOT burn.
– DO NOT place batteries where they
could become part of a local waste
landfill or municipal solid waste.
– Take them to an authorized
recycling centre.

5. BATTERY CHARGER

SPECIFICATIONS
CG 500 Li 48, CG 700 Li 48
Input: 220-240V ~ 50 Hz
Output: 48 V (Nominal) 1.5A
CGF 500 Li 48, CGF 700 Li 48
Input: 220-240V ~ 50 Hz
Output: 48V (Nominal)
CGD 500 Li 48 ,CGD 700 Li 48
Input: 220-240V ~ 50 Hz
Output 1: 48V (Nominal)
Output 2: 48V (Nominal)
CGDF Li 48
Input: 220-240V ~ 50 Hz
Output 1: 48V (Nominal)
Output 2: 48V (Nominal)
• The equipment shall not be exposed to dripping
or splashing, and no liquid container, such as
pots, shall be placed above the equipment.
• The charger is designed for rechargeable
lithium-ion batteries. Some other types
of batteries may explode, resulting in
personal injury and property damage.
• Only charge rechargeable batteries.
• The LED lights a flashing green during charging
and a steady green when charging is complete.
• The transformer external flexible cable cannot
be replaced; if the cable is damaged, the
whole transformer must be disposed of.
• The line voltage can be disconnected
by pulling the mains socket.
• The socket must be positioned close to
the tool and must be easily accessible.

CHARGING PROCEDURE

NOTE Battery is shipped not fully charged. It
is recommended to charge it before use to ensure
that the maximum operating time is reached.
The lithium-ion battery does not have a charge
memory and can be recharged at any time.
1. Connect the charger to an AC outlet.
2. Put the battery pack (1) into the charger (2).
CG 500 Li 48
CG 700 Li 48
2
EN - 4
3A
1.5A
1.5A
3A
3A
CGF 500 Li 48
CGF 700 Li 48
1
1
2
3
CGD 500 Li 48
CGD 700 Li 48
CGDF Li 48
3