Publicidad
Idiomas disponibles
Idiomas disponibles
EN
USER GUIDE
DIN RAIL BOX
FOR RELAY SWITCH
Reference: DRB-2-2-00 • Maximum intensity: please refer to the user guide of the
connected relay switch • Compatible DIN Rail: Type Ω EN 50022
Compatible relay switches: SIN-X-1-XX, SIN-X-2-XX, SIN-X-RS-XX, SIN-X-FP-XX
Operational temperature: -20°C to 40°C
Dimension: 87x27x58 mm • Weight: 46g • Warranty: 2 years
USE CAUTIONS
• Never use the device if it is not correctly installed and placed inside an electrical
panel in conformity with the current standards.
• Keep the product far away from liquids.
DETAILED USER GUIDE
Directly access the detailed user guide on the Support section on
nodon.fr/en/technical-support/
CONTACT
NodOn SAS
121 rue des Hêtres
45590 St CYR EN VAL (FRANCE)
AFTER-SALES SERVICE
www.nodon.fr/en section "support" support@nodon.fr
For user guides in other languages, please visit
www.nodon.fr/notices
DANGER OF ELECTROCUTION
BEFORE ANY INSTALLATION MAKE SURE THE POWER SUPPLY IS DISCONNECTED
TO AVOID ANY RISK OF ELECTROCUTION.
Directly cut the power supply from the breaker box to avoid any risk of electrocution. This DIN Rail
Box is designed to be used power up, a wrong installation can create a fire or an electric shock. The
DIN Rail Box must be installed and connected carefully following the instructions of this user guide.
NodOn
will not be responsible for any loss or damage resulting from a non-respect of the instructions
®
of this user guide. Cut the power supply before any operation and don't do any modification if the relay
switch LED located into the Rail DIN Box is ON.
INSTALLATION
Installation procedure
Cut the power supply of the electrical panel.
Unscrew the relay switch terminals you want
to connect.
Insert the relay switch on the DIN Rail Box
while respecting the direction of insertion of the
relay switch, the terminal block must be located
on the left (see figure 1).
Make sure the terminals are well unscrewed and
take care to not fold the pins located inside the
DIN Rail Box.
Screw the 6 screws of the relay switch to fix
both elements together (see figure 2).
T o facilitate the connection, unscrew
the 6 screws of the DIN Rail Box terminals.
Install the box with the relay switch on
the DIN Rail Box of the electrical panel.
Connect the terminals according to your
module according to the diagram (see figure 3).
Terminals
Terminal
number
Relay
DRB-2-2-00
switch
Light guide
Button
Terminals
Turn the power supply back on and check that the LED on the module lights up
through the light guide.
For the pairing or configuration of your module, please refer directly to its user
guide.
Recommandation
The power of each module must not
exceed 1500W if 3 DIN rail boxes are
placed in the switchboard as shown
in figure 4.
figure 1
figure 2
Terminal
number
SIN
1
2
➔
2
1
➔
3
3
➔
4
5
➔
5
6
➔
1 2 3
6
4
➔
figure 3
figure 4
4
5
6
Publicidad
