Publicidad
TxConfig-DIN43650 and TxConfig-M12
Interface
Quick Guide
TxConfig-DIN43650 and TxConfig-M12 are configuration interfaces
for transmitters with DIN and M12 interface and can power the
transmitters. They are used with the TxConfig II configuration
software.
FEATURES
Easy installation.
•
USB communication with the PC and serial communication with the
•
transmitters.
Powers the transmitters without requiring a battery or external
•
power supply.
Easy electrical connections.
•
Compatible with USB 1.1, 2.0, and 3.0.
•
Cable length: 1 m.
•
Operating System: Windows.
•
ELECTRICAL INSTALLATION
Connect the interface to the transmitter as shown in Figure 1
•
(DIN43650) or Figure 2 (M12).
Connect the interface to the PC.
•
There is no need to install drivers.
•
To configure a device, run the TxConfig II software.
•
OPERATION
Follow the instructions in the TxConfig software.
STATUS LED
LED on: The interface was installed and is ready for use.
•
LED blinking: The device is communicating with the transmitters.
•
Warning: There is no isolation on the USB interface
of this product. Be careful when using it with field-
installed transmitters, as short circuits or ground loops
may occur.
ELECTRICAL CONNECTIONS
1. TxConfig-DIN43650
English
2. TxConfig-M12
Figure 1
Figure 2
T x C o n f i g - D I N 4 3 6 5 0
a n d T x C o n f i g - M 1 2
I n t e r f a c e
Q U I C K
G U I D E
WARRANTY
Warranty
conditions
are
available
www.novusautomation.com/warranty.
on
our
website
QG 5010048 V1.0x A
Publicidad
