Unit Placement - Denver MFR-400 Manual De Instrucciones

Operating Instructions
IMPORTANT: Before plugging in the unit, make sure the switch
on the back of the unit is in the OFF position.

Unit Placement

Locate unit a minimum of 3" (7.6cm) f rom wall or structure to allow
proper ventilation to the back and top of the unit.
Plugging in your Unit
FOR HOME USE: Insert the AC power cord provided, by f irst
inserting the AC power cord into the АС-in port, and then
plugging into an AC wall outlet. NOTE: This unit only works on
230-240V.
FOR MOBILE USE: insert the DC power cord into the DC-in port.
In a car, RV, or boat, make sure the motor is on before plugging
the DC power cord into the 12V cigarette lighter/DC outlet.
Do not use DC power when motor is turned off.
Turning on your Unit
FOR COOLING: Flip the power switch
from OFF to COOL setting. A green light
will indicate that the unit is in cooling
mode.
FOR WARMING: Flip the power switch
f rom OFF to WARM setting. A red light
will indicate that the unit is in warming
mode.
ENG 4