Maintenance; Maintenance Schedule - Husqvarna DM 230 Manual De Usuario

5. Turn the drill bit counterclockwise to install it. Tighten
fully.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
WARNING:
disconnect the power cord before you do

maintenance.

Maintenance
Make sure that movable parts function correctly and
move freely.
Make sure that the cutting tool is sharp and clean.
Make sure that the PRCD functions correctly.
WARNING:
100-120V type sold in United Kingdom and
Ireland. Refer to
Examine the power cord, other cables, and the power
plug for damage.
Make sure that the handles and holding surfaces are
dry, clean and free of oil and grease.
Make sure that the product is clean.
Examine the shaft seals for damage/water leakage.
Make sure that the nuts and screws are tight.
Make sure that the power switch operates correctly.
16
Maintenance
Read and understand the
To prevent injury,
Not applicable for
PRCD on page 8 .

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Speak to a Husqvarna service agent.
Before After
each use each use
*
*
X
* *
* *
X X
X
After the
Daily each 300
first 100 h
*
X
1473 - 001 - 04.04.2022
After
h