Safety Information - Axis TW1104 Guia De Instalacion

English

Safety information

Hazard levels
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NO TICE TICE
NO NO TICE
Indicates a situation which, if not avoided, could result
in damage to property.
Safety instructions
NO TICE TICE
NO NO TICE
•
The Axis product shall be used in compliance with
local laws and regulations.
•
Store the Axis product in a dry and ventilated
environment.
•
Use only applicable tools when installing the Axis
product. Using excessive force with power tools
could cause damage to the product.
•
Do not use chemicals, caustic agents, or aerosol
cleaners.
•
Use a clean cloth dampened with pure water for
cleaning.
•
Use only accessories that comply with the technical
specification of your product. These can be provided
by Axis or a third party. Axis recommends using
Axis power source equipment compatible with your
product.
•
Use only spare parts provided by or recommended
by Axis.
•
Do not attempt to repair the product yourself.
Contact Axis support or your Axis reseller for
service matters.
Magnets
Axis and/or its suppliers do not accept any
responsibility for damage caused by the improper
handling of the product. Please ensure all users of
the product are made aware of these safety warnings
before use.
WARNING
This product uses very strong magnets
•
Magnets can cause heart pacemakers to
malfunction.
•
The operation of heart pacemakers will be affected
by the close proximity of magnets.
•
A user's health can be negatively impacted by an
affected pacemaker.
Always keep this product away from heart pacemakers
or magnetically sensitive items.
CAUTION
This product uses very strong magnets
•
The magnets in this product are very powerful and
will pull together with extreme speed and force,
causing trapping injuries.
To limit potential trapping injuries during fitting,
removal, and storage, always hold the side edges
of both mouldings, where there is integral spacing
between both plates when combined.
To separate the magnets, use a wooden table or desk
and overhang one moulding over the table edge. Apply
a strong, downward pressure on the moulding and it
will slide and eventually detach from the others. Once
separated, always store mouldings with a minimum of
500 mm (20 in) away from each other.
Do not remove the magnets from the moulding.
Always keep out of reach of children
NO TICE TICE
NO NO TICE
This product uses very strong magnets
•
Magnets can damage magnetically stored media.
Always keep the product away from credit cards and
other magnetically stored media.
Français
Informations sur la sécurité
Niveaux de risques
DANGER
Indique une situation dangereuse qui, si elle n'est pas
évitée, entraînera le décès ou des blessures graves.
AVERTISSEMENT
Indique une situation dangereuse qui, si elle n'est pas
évitée, pourrait entraîner le décès ou des blessures
graves.
ATTENTION
Indique une situation dangereuse qui, si elle n'est
pas évitée, pourrait entraîner des blessures légères ou
modérées.
A A A VIS VIS VIS
Indique une situation qui, si elle n'est pas évitée,
pourrait endommager l'appareil.
Consignes de sécurité
A A A VIS VIS
VIS
•
Le produit Axis doit être utilisé conformément aux
lois et règlements locaux.
•
Conserver ce produit Axis dans un environnement
sec et ventilé.
•
Utiliser uniquement des outils recommandés pour
l'installation de l'appareil Axis. L'application
d'une force excessive sur l'appareil avec des outils
puissants pourrait l'endommager.
•
Ne pas utiliser de produits chimiques, de substances
caustiques ou de nettoyants pressurisés.
•
Utiliser un chiffon propre imbibé d'eau pure pour le
nettoyage.
•
Utiliser uniquement des accessoires conformes
aux caractéristiques techniques de votre produit.
Ils peuvent être fournis par Axis ou un tiers.