JYSK HUGLO Instrucciones De Montaje página 2

English English
Install the brackets
1
Shorten the blind
2-8
Activate the motor
9
Activate the motor by moving the switch to 1.
Install the blind
10
Remote; Changing the battery
11
Remote holder
12
Pair a remote
13
Select a desired channel for the blind using the left or right button
13.1
on the remote control. (Select a channel between 1-15) Do not use
channel 0, Channel 0 controls all channels at the same time.
The next step needs to be done within 10 seconds. Please read the
step before continuing .
Press the program button (P1) on the motor until the blind steps.
13.2
Press the pair button (P2) on the back of the remote control.
Press the pair button (P2) again and click the down button on the
remote. The blind will step at every press of a button. The remote
is now paired with your blind.
The motor will automatically run once the up or down button
is pressed. Stop the blind by pressing the center button on the
remote.
If the motor does not respond, repeat the steps above.
Check direction of rotation
14
WARNING: risk of damage. Stop the blind before reaching the end
positions.
Shortly press the down button to check if the blind unrolls the
14.1
right way. If the blind moves up, the rotational direction must be
changed.
To change the direction of rotation hold the program button (P1)
14.2
on the motor until the motor steps 3 times to confirm that the
direction of rotation is changed.
End limits must be programmed to use a blind properly and to
prevent it from being damaged.
Enter setup mode
15
To program the end limits the motor has to be in setup mode.
15.1
This is done by pressing the following button combination within
10 seconds. Press pair button P2 on the remote (the motor steps
once). Press the up button on the remote (the motor steps once)
and click the pair button P2 button once more (the motor steps
once). The motor is now in setup mode
The setup mode must be activated in the channel to which the
blind is paired.
MN200101_20210326
MN200100_20201210.indd 2 MN200100_20201210.indd 2
English
Set bottom & top position
16
Press the down button to lower the blind when the desired bottom
16.1
position is reached click the center button to stop the blind.
Hold the center button for 5 seconds to save the bottom position.
(The motor steps once)
If the blind does not step, repeat from step 15
Press the up button to raise the blind when the desired top
16.2
position is reached click the center button to stop the blind.
Hold the center button for 5 seconds to save the top position.
(The motor steps once)
Set favorite position (optional)
17
Place the blind at a desired favorite position between the top and
17.1
bottom position.
To program the favorite position press the following button
combination.
17.2
Press pair button P2 on the remote (the motor steps once). Press
the center button on the remote (the motor steps once) and click
the center button once more (the motor steps once). The motor
has now saved the favorite position.
To move to your favorite position hold the center button for 3
seconds.
To delete the favorite position repeat step 17.2. After deleting the
favorite position you are able to set a new favorite position by
repeating step 17.1 once again.
Recharge the battery
18
Use a micro USB cable to charge the motor.
LED light flashes red during operation;Charge the battery.
18.A
18.B LED light flashes green;battery is charging.
18.C
LED light constantly green;battery is fully charged.
Reset the blind
19
Factory reset will delete the end limits and remove the connection
to any paired remote.
To reset the blind to factory defaults, hold the Program button P1
19.1
button until the blind steps four times.
2/40
26-3-2021 12:29:57 26-3-2021 12:29:57