Descargar Imprimir esta página

Control Panel; Handle Installation - Danby Designer DUF167A4WDD Manual Del Propietário

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS

CONTROL PANEL

TEMPERATURE SETTING
Press the arrow buttons to set or adjust the
temperature.
The temperature can be set between -14°C to -24°C
(7°F to -11°F).
The recommended temperature setting is -18°C
(0°F).
FAST FREEZE FUNCTION
This function should be used when the appliance is
fi rst turned on, when it has been fi lled with groceries
or if the door has been open for an extended
period. This function will run the compressor
constantly to reach the coldest temperature as
quickly as possible.
Press and hold the fast freeze button for three
seconds to activate the fast freeze. The LED indicator
will illuminate.
To cancel the fast freeze function press and hold the
fast freeze button until the LED indicator turns off.
When the fast freeze cycle has fi nished or is
canceled the appliance will revert back to the last
set temperature.
TEMPERATURE SCALE
To switch between °C and °F, press the °C/°F
button, the corresponding indicator light will
illuminate.
OPEN DOOR ALARM
This appliance is equipped with a door alarm that
will sound if the door is left open for more than 3
minutes. The alarm will beep and the display will
fl ash continuously until the door is closed.

HANDLE INSTALLATION

The appliance ships with the handle inside the
cabinet to protect it from damage. It must be
installed by the end user. The appliance should be
unplugged before installing the handle.
1. Position the handle over the exposed door
handle posts.
2. Remove the two screws from the side of door
with a screwdriver, insert screws into the handle
bracket, fi x it to the side of door and tighten it
until snug.
Note: The handle may look slightly different based
on the colour of the appliance.
4

Publicidad

loading

Este manual también es adecuado para:

Duf167a4bsldd