Door Reversibility - AEG AWUS052B5B Manual De Instrucciones

70 www.aeg.com
It must be possible to
disconnect the appliance
from the mains power
supply. The plug must
therefore be easily
accessible after installation.
3.3 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
3.4 Levelling
When placing the appliance make sure
that it stands level. This can be achieved
by two adjustable feet at the bottom in
front.
3.5 Installing the upper
bracket
Fasten your appliance:
• Use two screws to install the upper
bracket on the top of the appliance.
• Put the appliance in the cupboard and
use two screws to fix the upper
bracket on the cupboard.

3.6 Door reversibility

WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
Tools you need:
• cross-shaped screwdriver,
• putty knife or thin-blade screwdriver.
1. Make sure the appliance stands
upright.
2. Open the door and remove all wine
bottles from the shelves. Close the
door.
3. Unscrew the 4 screws that connect
the bottom hinge. Put the bottom
hinge in a safe place together with
the screws.
4. Remove the door and put it on a soft
surface.