Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (cont'd)
5. Bend the conduit:
If bending 1-1/2" to 2" EMT or IMC:
a. Place one foot on the loading pedal, as shown.
Engaging the Loading Pedal
(for 1-1/2" to 2" EMT or IMC Only)
b. Press and hold BEND. The bender will pull up
the roller support. When the roller support
contacts the stop, remove your foot from the
loading pedal.
c. Release the switch as you approach the desired
angle of bend.
d. Press BEND momentarily until the bend is
complete.
• Do not allow a bend or coupler to go over the
roller supports.
• Do not allow the trailing end of the conduit to go
over the roller supports.
Failure to observe these warnings can result in
severe injury or death.
Greenlee Textron / Subsidiary of Textron Inc.
All manuals and user guides at all-guides.com
®
555
Deluxe Electric Bender
If bending any other size or type of conduit:
a. Press and hold BEND.
b. Release the switch as you approach the desired
angle of bend.
c. Press BEND momentarily until the bend is
complete.
6. Press UNLOAD. The shoe will rotate backward.
Note: If bending EMT or IMC, the roller support unit
will drop to its original position.
7. After the shoe has rotated backward 15° to 20°,
release the switch. After the shoe stops completely,
twist the conduit to release it from the hook.
Remove the conduit from the shoe.
8. Press and hold UNLOAD until the shoe has rotated
back to 0°.
10
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Publicidad
