Installation Specifications; Specifications Of Parts And Materials; Installing The Cinderella Incineration Toilet - Cinderella FREEDOM PM02CS03 Manual Del Producto

2.4 INSTALLATION SPECIFICATIONS

2.4.1 SPECIFICATIONS OF PARTS AND MATERIALS

ITEM
Ventilation pipes
Elbow (outlet air)
Flue terminal cap
NOTE!
•
•
•
•
•

2.5 INSTALLING THE CINDERELLA INCINERATION TOILET

It is essential to ensure proper ventilation in accordance with the guidelines in this manual to guarantee the
functionality of your new Cinderella toilet. Improper installation may cause malfunction, wear or odours and will
void the warranty. Read each section carefully before starting the installation of the toilet. Always make sure that
the work is carried out by professionals in accordance with local regulations.
CAUTION!
•
•
•
•
•
WARNING!
Before cutting any holes, always check that in doing so you will not cut through any electrical
wiring or water pipes.
8
SPECIFICATIONS
Cinderella Freedom is required to be installed with 110 mm pipes with a smooth
inner surface and a minimum inner diameter of 102 mm. The pipe material must
be specified for temperatures over 100 °C and preferably of a PP or CPVC type. We
strongly recommend using the Original Cinderella PP-quality pipes.
Cinderella Freedom is required to be installed with a smooth curved elbow that
minimises the restriction of the air flow. We strongly recommend using the Original
Cinderella elbow, 87° w/ drain.
Cinderella Freedom is required to be installed with a flue terminal cap that prevents
intrusion of rainwater and that has a minimum restriction of the air flow. Wind fans
or similar are not to be used when venting the Cinderella incineration toilet. We
strongly recommend using the Original Cinderella flue terminal cap.
The inside of the ventilation pipe must be smooth and not embossed or grooved.
Never use a mesh net in the ventilation pipe, as this might restrict the airflow in the
system.
The elbow must be accessible when installed, so that the drainage pipe can be rinsed
and the outlet pipe cleaned.
Cinderella Freedom is approved for use in bathrooms/wet rooms (IP 34 classified), but
water must not be splashed over the external parts of the toilet.
The toilet must be placed on a firm and level base. Your Cinderella appliance may be
installed on a heated floor.
Upon installation of the appliance, the technical and administrative regulations of the
country in which the toilet is installed must be adhered to. We recommend that you
contact your local dealer for planning and installing your Cinderella toilet.
Never use bends in addition to the elbow.
If the pipe perforates the roof surface, ensure that it is in compliance with building
regulations.
Do not use any flexible ducts or pipes when installing the Cinderella toilet.
Never connect more than one appliance to the vent.