Blanco TERA ND Información Técnica página 11

INSTALLATION MOD. BLANCOTERA ND
Rinse pipes thoroughly
Screw the threaded stem (12-D) into the body holes .
Insert the mixer in the hole of the sink top.
Insert the plastic base (11).
Insert the shaped washer (12-B) and the horseshoe flange (12-C) in the threaded rod (12-D).
Screw the nut (12-E) fixing the mixer to the sink.
Connections
- see Fig.3 and fold-out
A - Cold water inlet pipe (blue arrow upwards)
B - Heating boiler inlet pipe (blue arrow
downwards)
C - Hot water from heating boiler (red arrow
upwards)
- Connect the flexible pipe with blue arrow
downwards to the boiler inlet (blue colour),
placing the washer (12 A)
- Connect the flexible pipe with red arrow
upwards to the boiler outlet (red colour),
placing the washer (12 A)
- Connect the flexible pipe with blue arrow
upwards (A) complete with flow reducer (14) to
the stopcock , placing a washer (14 B).
- Pay attention to the correct position of the
gaskets (12 A - 14 B)
After installation, loosen the antisplash and let
the water flow so that the foreign materials (chips
or hemp residues) are eliminated. Check the
seal of the connections.
.
Fig. 1
- see Fig. 1 and fold-out
7
8
Fig. 2
B
C
Fig. 3
C
W
BOILER
4
5
6
A
B
K
A
8