Installing The Drag Stake - Toro 58604 Manual Del Operador

2. Install the middle dash panel. Route the engine
switch cable through the hole on the left side of
the panel as shown in
Figure 10
1. Bolt—M6 x 40 mm (4)
2. Middle dash panel
Figure 11
3. Tighten all fasteners.
4. If desired, secure the drive cable using a cable
tie.
Figure 11.
g358244
3. Drive cable
4. Nut—M6 (4)
g361564
5. Insert the Z-bend end of the drive cable into the
middle hole of the drive-control lever.
Note:
Ensure that there is no excess slack in
the cable and that the lever remains in the full
up position.
1. Drive-control lever holes
3

Installing the Drag Stake

Parts needed for this procedure:
1 Lock pin
1 Drag stake
Procedure
Install the drag stake at the desired height; refer to
Adjusting the Drag Stake (page
9
Figure 12
17).
g358470