Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 Controller display instructions:
The main interface of the shutdown state displays "OFF" ；
The main interface of the power-on state displays the inlet water temperature ；
Display fault code when fault occurs ；
LED 1: When cooling, LED 1 lights up and flashes when defrosting. 。
LED 2: When heating, LED 2 lights up.
5.3 Definition of function key：
On/Off button;"
" button.
In the main interface, long press this button for 3 seconds to turn on or off.
In the parameter interface, parameter setting interface, press this button to return to the main interface.
Long press "
" & "▲"Key as 5 Seconds to enter the password input interface, combined with "▲",
" &
"M" Key, After entering the three-digit password of 123, enter the parameter interface, press"M" Key under the
corresponding parameter interface to enter the parameter setting states, and modify the parameters with
"
"
and "
" Key, all parameters are allowed to be modified by using this way ,
Query and Set the Parameters.:
"M" button:
Long press "M" as 3 Second to Switch Heating or Cooling.
Short press "M" to query the status parameters of the unit, and you can combine the "
" and "
" buttons to
check the parameters.
In the system parameter Query states, Click "M"Key under the corresponding parameter interface to enter the
parameter setting state, Combine the
"
" and "
" to modify the parameter, and press the "M" key again to
Quit the Parameter Setting states to return to the parameter Query state, Only d/H/J Parameters be modified if use
this way to entering,
Up and down buttons: "
" and "
" buttons.
In the main interface, you can use this button to adjust the current setting temperature.
2021-2022
Page 10 / 61
Publicidad
