Assembly; Operation - Ryobi PCL661 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Operate in a well ventilated area. Do not block vents.
Keep them clear to allow proper ventilation.
APPLICATIONS
You may use this product for the purpose listed below:
 To illuminate distant objects and areas requiring additional
light
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
 Insert the battery pack as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.

OPERATION

If the light flashes during operation, try recharging and rein-
stalling the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
WARNING:
Battery products are always in operating condition.
Therefore, remove the battery pack when the product is
not in use or when carrying at your side.
INSTALLING/REMOVING BELT HOOK (NOT
INCLUDED)
See Figure 2, page 7.
The belt hook is interchangeable. It may be installed on
either side of the base.
 Align hole in belt hook with hole in tool's base.
 Install screw to secure belt hook in place.
 To uninstall, remove screw and then belt hook.
TURNING THE SPOTLIGHT ON AND OFF
See Figure 3, page 7.
The spotlight has four settings: high, medium, low, and off.
 High: Press and release the switch trigger once.
 Medium: Press and release the switch trigger twice.
 Low: Press and release the switch trigger three times.
 Off: Press and release the switch trigger a fourth time.
OVER TEMPERATURE PROTECTION
If overheating occurs, the light will attempt to cool itself by
dimming.
If dimming does not cool the light sufficiently, it will shut off.
As soon as the unit reaches normal operating temperature,
it can be turned on again. If it shuts off, allow approximately
10 minutes of cool-down time before attempting to resume
operation.
5 — English