Hendi 212172 Manual De Instrucciones página 6

Operation
• Clean the baking plate by a moist cloth before
first time of using.
• Connect the power plug with a suitable electrical
outlet.
• Switch on the appliance with the ON/OFF switch,
it will light up. Then turn the temperature con-
trol knob clockwise to select the required baking
temperature.
• When the baking plate is heating up, the Orange
heating indicator light up.
• Wait 5 to 10 minutes for preheating. Once the set
temperature is reached, the Orange heating indi-
cator will go off automatically.
• Now it is ready for baking. Lightly coat the lower
baking plate with butter, margarine or suitable
baking oil. Then, spread the waffle dough evenly
on the lower baking plates. Do not pour too much
tough.
• Close the lid by using the handle.
• Orange heating indicator lights up again for heat-
ing up.
• Timer: Switch on the timer, when finished the
timer will sound.
EN
• Remove the waffles using a waffle fork (not sup-
plied). Never use abrasive utensils. This may
damage the non-stick coating of the baking
plates. Never use bare hands to touch the food.
Danger of burns!
RESET the Hi-limiter (thermal cut-out)
NOTE: The RESET button is at the back of the ap-
pliance.
• Unplug the appliance electrical power outlet.
• Allow the appliance to completely cool down.
• Press the RESET button of the Hi-limiter (ther-
mal cut-out). You should hear a click sound.
• Plug into the socket and you can use it again.
6
Note: When you pour the batter onto the hot bak-
ing plate, you might hear some slight cracking
noise caused by difference in temperature. This
is normal.
• Close the appliance if more waffles are to be
baked, in order to maintain the temperature.
• After use: set the Temperature control knob to
zero degree in upwards position until the Orange
heating indicator goes out.
Attention! Disconnect the power plug from the
electrical outlet and let it cool completely be-
fore cleaning and storing.
Attention! When the timer is finished the pow-
er won't be cut. To switch the appliance off turn
temperature control to zero degree.
Note: Due to the manufacturing residues, the ap-
pliance may emit slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated
during operation.