Rear Panel; Installation Advice - Montarbo MDI-2U Manual De Uso

MDI-2U
CONTROL PANEL
FRONT PANEL
3
1
2
1 OUTPUT LEVEL
Turn this knob clockwise to set the general output level.
2 ON
This LED signals that the device is powered on and ready for use.
3 MONO
Press this switch to convert the stereo signal to mono.
4 PHONES
Connect your headphones to this output via 6.35mm jack. The output level is controlled
by the Output Level knob.
5 USB INPUT
Connect the USB cable supplied to power the device and enable audio streaming from
your computer.
10
5
4

REAR PANEL

6
8
6 XLR OUTPUTS
Connect a mixer, studio monitor or PA system to these outputs using an XLR-M/F cable
wired as follows:
PIN 1 - Ground (earth),
PIN 2 - Positive (+ or hot),
PIN 3 - Negative (- or cold).
7 PAD
Pressing this switch reduces the output level by -30dB. Use the PAD in situations where
there is very high input signal that is close to distorting.
8 GROUND
Pressing this switch lifts pin-1 on both XLR-M outputs.
Use this function to earth hums and loops.

INSTALLATION ADVICE

No additional drivers are required. Connect the device to the USB port on your computer; it
will be automatically recognised.
User manual
7
6
11