Publicidad
Auto leveling
1.
In "Settings" → "Leveling m ode"
2.
2mm feeler gauge between the nozzle and the hot bed → If the gap is to o thin or too large, click "Z+" or "Z-" on
the interface to adjust the gap to slightly more than 0.2 mm(the distance between the nozzle and the hot bed should
be about 0.2mm). At 0.2 mm the feeler can easily pass through the gap between the nozzle and the printing platform.
Restore hot end to original
home position
*When using the auto level feature , we suggest that adding a ra� from
the build plate adhesion sec�on in so�ware se�ngs
Auto-level the printing surface
16 point precise bed height
measurement
Printer
will
automatically
Printer will automatically
compensate
for
variable
bed height
29
Publicidad
