Functions And Display - dB Technologies DEM 30 SYSTEM Manual Del Usuario

4. FUNCTIONS AND DISPLAY

A quick view of the parameters shown in the transmitter and receiver displays is shown below:
U - AF levels (stereo/mono)
V - GROUP - CHANNEL indicator
W - STEREO/MONO mode
X - BATTERY CHARGE LEVEL
Y - SIGNAL RECEPTION LEVEL
Z - FUNCTION SELECTION
The sequence for selecting and increasing the values for the transmitter is as follows:
- Hold SET depressed for a few seconds to select the parameters that can be edited.
- The first parameter, according to a preset sequence, starts flashing.
- Use the relevant arrows to increase/decrease the value of the parameter concerned.
The sequence for selecting and increasing the values for the receiver is as follows:
- Hold SET depressed for a few seconds to select the parameters that can be edited.
- The first parameter, according to a preset sequence, starts flashing.
- Use the relevant UP/DOWN arrows of the receiver to increase/decrease (or select ON/OFF, depending on the
parameter) the value concerned.
- It is possible to either quit the sequence by pressing ESC or continue to edit parameters.
DEM 30 IEM
18
TRANSMITTER
U
V
RECEIVER
U
V
W
Z
Y
X
Code 420120320 REV. 1.0
English