Team kalorik TKG FE 1010 Manual De Instrucciones página 6

ASSEMBLY
Silicone pad installation : Before the juice cup is installed, please make sure the silicone
pad of the pulp outlet at the bottom of the juice cup is properly installed.
The silicone pad of pulp outlet must be inserted into the rectangular slot.
Note : When cleaning the bowl, make sure to slide the pad out and run water through
the pulp ejector to remove excess food debris.
Assemble the bowl to the base : match the three holes on the bottom of the bowl with
the three bosses of the base. Just put the bowl onto the base.
• Assemble the Filter onto the bowl (match the opening above the holder of
components of the filter net with the groove on the container).
• Place the Auger in the centre of the Filter
• Twist the Auger clockwise until it drops into place.
• Place the Bowl cover onto the bowl.
• Turn the Bowl cover clockwise until the lid clicks into the locked position. The arrow on
the Bowl cover will line up with the arrow on the motor base.
USING THE SLOW JUICER
1. Once all parts are securely in place, plug in the appliance.
2. Place one of the collectors under the pulp ejector, and either a glass or the other
collector under the juice spout.
3. The Slow Juicer has 3 settings
ON – this starts the motor for juicing.
OFF (O) – this stops operation.
REV (R) – this moves the Auger in the opposite
direction.
TKG FE 1010 6