Publicidad
Idiomas disponibles
Idiomas disponibles
M8 x 60 mm
(4 used in this step)
To avoid causing damages to the thread, DO NOT over-tighten the bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Attach the Short Stretcher (E) between the Legs (B and C) with the tenons fully inserted. Make sure that
the slant holes on the stretcher will face the floor when the unit is turned upright.
3. Lay one Seat Frame (A) upside down on a smooth and protective surface.
4. Fit the leg assembly to the corners of the Seat Frame (A). Insert four 60 mm Bolts (1) with Lock Washers
(2) and Flat Washers (3) through the drilled holes on the corner blocks and screw into the threaded inserts
on the Legs (B and C).
NOTE: DO NOT fully tighten all the bolts until the unit has been adjust and all the legs are levelled so
that they do not wobble. Once adjusted, go back and tighten while making sure that the unit remains level.
Assembly Instructions
Bolt
①
DO NOT fully tighten the bolts initially until all the bolts are ready to assemble.
Lock Washer
(4 used in this step)
②
4
Flat Washer
(4 used in this step)
③
Publicidad
