How To Use - Lionelo Luca Manual De Usuario

handlebar up or down to the desired position. Then tighten the screw and
secure the quick assembly lever (fig. 5).
FOLDING LO-LUCA SCOOTER
• Release the quick assembly lever and loosen the securing screw. Push the
locking part and, holding it, move the handlebar down to the lowest position.
Then tighten the screw and secure the quick assembly lever (fig. 6).
• Push the locking part and, holding it, pull the handle out of the handlebar
guide and put it into a plastic holder (fig. 7).
• Release the quick assembly lever and loosen the securing screw. Pull up the
retaining bracket and fold the scooter's frame. The screw and the bracket will
automatically fit into the guide (fig. 8).
• Tighten the securing screw and secure the quick assembly lever (fig. 9).

HOW TO USE

Place one foot on the platform, then grab the handlebar and choose your direction.
With the help of second foot push yourself from the floor to start moving. To
change the direction gently move the handlebar. For the first ride it is recommended
to practise in an open space without obstacles.
HOW TO USE THE BRAKE
press the rear mudguard with your left or right foot, shifting your weight to the
back of the vehicle. Control it accordingly while stopping to avoid tipping over.
Caution – the mudguard may be hot, avoid touching it to prevent burns.
WHEEL REPLACEMENT AND BEARING MAINTENANCE
INSTRUCTIONS
If the wheels show clear signs of wear, consider replacing them. Using an Allen
key, remove the screw that secures the wheel to the scooter frame. Remove the
retaining pin and then the wheel. If the technical condition of the bearings is
satisfactory, keep them for future re-assembly. To do so: remove the bearings,
clean them and apply the right amount of grease. Mount them again in the new
wheel. If the technical condition of the bearings is inadequate, buy a new one
and repeat the assembly process.
‑ 5 ‑ EN