Publicidad
Idiomas disponibles
Idiomas disponibles
12.6
Cutting
When shearing thicker materials, workpiece tends to separate blades so tension may have to be
increased on the lower blade. Rotate cap screw against tension bar to increase tension on lower
blade. Be sure blades do not interfere with each other. Material stop can be used to make
repeated cuts to a desired length. Set material stop to desired position and secure locking knobs.
Make sure metal stop angle iron is pointed "down" for shearing. Do not reach in back of machine
to grasp fallout piece.
13
MAINTENANCE
After each workshift:
Keep the device clean of shavings.
After 25 work hours:
Grease the mechanical parts with suitable lubricant
13.1
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
14
TROUBLE SHOOTING
Trouble
Bad bending result
Lever let be hard to turn
HOLZMANN MASCHINEN GmbH
Possible cause
Bending roller set not parallel
Sheet to thick
Sheet to long
To insufficent lubrication
www.holzmann-maschinen.at
MAINTENANCE
Solution
Adjust the bending roller with
the corresponding knobs.
check max. sheet thickness
Support the long sheet
Lubricate the mechanical
parts and clean the rollers
from oil
17
UBM 305
Publicidad
