Possible Misuse - Hilti TE 30-A36 Manual De Instrucciones

3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless (battery-powered) combihammer with pneumatic hammering mecha-
nism. It is designed for drilling in concrete, masonry, wood and metal. The product can also be used for light
to medium-duty chiseling on masonry and surface finishing work on concrete.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3

Possible misuse

• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment.
3.4 ATC
The power tool is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the power tool will suddenly pivot about its own axis in the opposite
direction. ATC detects this sudden pivoting movement of the power tool and switches the tool off immediately.
For ATC to function correctly, the power tool must be free to pivot.
After the power tool has cut out due to ATC, switch it back on again by releasing the control switch
for a moment and then pressing the switch again.
3.5 Motor protection system
The tool is equipped with a motor protection system. The system monitors current input and motor
temperature and thus prevents the tool from overheating.
If the motor is overloaded through application of excessive working pressure, the power tool's performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
16 English
1
Chuck
@
Depth gauge release button
;
Depth gauge
=
Function selector switch
%
Forward / reverse switch
&
Control switch
(
Battery state of charge / fault display
)
Release buttons / battery state of charge
+
display
Battery
§
Side handle
/
2173711
*2173711*