allen+roth GAT17001ES-L Manual página 9

ASSEMBLY INSTRUCTIONS (Continued) ASSEMBLY INSTRUCTIONS (Continued)
4. Screw Clip Bolt to Clamp Bottle Tightenly
1. Insert the clip bolt into gas bottle clamp.
2. Rotate clockwise to screw the clip bolt until the gas tank/
gas bottle is Clipped Tightly.
5. Place Fire Glass Into Burner
CAUTION: Do NOT dump fire glass out of package. Carefully
place fire glass by hand so dust does not clog burner.
CAUTION: Use only Mr.Bar-B-Q Products LLC. factory-authorized
fire glass. The use of any fire glass that is not factory-authorized
can be dangerous and will void your warranty.
Caution: Do NOT cover igniter.
WARNING: To ensure proper function, the igniter cover on this
burner shall be free of fire glass at all times.
6. Disconnect LP Gas Tank
CAUTION: LP gas tank must be properly disconnected
and removed prior to moving this fire pit.
Do NOT attempt to disconnect the gas tank or any gas
fitting while the outdoor fire pit is in use.
1. Turn the control knob to the " OFF" position.
2. Rotate counterclockwise to screw the clip bolt loosely.
3. Rotate LP gas tank counterclockwise until it is loose.
Remove LP gas tank.
4. Place the protective cap cover.
5. Store the LP gas tank in a proper location, per LP gas
tank instructions.
4 4
5 4
6 4
9
BB