Controls - GE ADHL22 Manual Del Propietário

Controls

Appearance may vary by model.
Cont rols
NOTE: When t he bucket is full or removed, t he cont rols cannot
be set .
1. Power Pad
Press t o t urn t he dehumidifier on and off.
NOTE: Turning off t he power by pressing t he Power but t on
does NOT disconnect t he appliance from power supply.
Cont rols t he fan speed.
Press t o select eit her High, Medium, Low, or Smart Dry fan
speed.
Set t he fan cont rol t o High for maximum moist ure removal.
When t he humidit y has been reduced and quiet operat ion is
preferred, set t he fan cont rol t o Medium or Low. Smart Dry
compares t he set humidit y level wit h t he act ual humidit y and
adjust s t he fan speed aut omat ically.
3. Display
Shows t he set % humidit y level while set t ing, t hen shows t he
act ual (+/ – 5% accuracy) room % humidit y level.
The humidit y level can be set wit hin a range of 35%
increment s or in Nonst op mode for cont inuous operat ion. To
set t he unit for cont inuous operat ion, press t he
t he "Nonst op" indicat or light is illuminat ed.
NOTE : If Nonst op is select ed, t he dehumidifier will operat e
cont inuously at it s maximum dehumidificat ion set t ings if
at t ached t o a hose t o drain or unt il t he bucket is full. For
drier air, press t he
(%). For damper air, press t he
percent value (%). When you first use t he dehumidifier, set
for t he dehumidifier t o achieve t he humidit y level. If you st ill
have damper air t han desired, set t he humidit y level t o a lower
set t ing or select Nonst op for maximum dehumidificat ion.
5. Filt er Timer
will glow t o remind you t o clean t he filt er. Remove t he filt er and
clean it .
Press and hold Filt er but t on for 3 seconds t o reset t he filt er
reminder. See t he Care and Cleaning sect ion.
4
pad and set t o a lower percent value
pad and set t o a higher
6. Delay Off
While t he dehumidifier is operat ing press t he Delay but t on.
Press t he
want t he dehumidifier t o cont inue t o operat e before t urning
Off.
NOTE:
showing t he current humidit y aft er 5 seconds have passed.
Pressing t he Delay but t on will display t he number of hours left
on t he delay.
Delay On
While t he dehumidifier is off press t he Delay but t on.
Press t he
want t he dehumidifier t o remain off before t urning On.
NOTE: The display will show t he number of hours left unt il t he
dehumidifier t urns on.
To cancel t he Delay:
Press t he Delay but t on once, t he hours remaining on t he Delay
will appear on t he display. Press t he Delay but t on again and t he
Delay will be cancelled.
7. Pump (on some models)
t o act ivat e t he int ernal pump for aut omat ic removal of
pad unt il
condensat e. The int ernal pump indicat or light will remain
illuminat ed aft er 3 seconds. Press t o deact ivat e t he pump.
Before t urning on t he pump, ensure t he hose is connect ed.
8. Empt y Indicat or
The "Empt y" indicat or will blink when t he bucket is ready t o be
empt ied, or when t he bucket is removed and/ or not replaced in
t he proper posit ion.
9. WiFi Connect Pad (on some models)
Enables connect ion of t he dehumidifier t o t he home WiFi.
GEAppliances.com/ connect .
/ but t ons t o select t he number of hours you
/ but t ons t o select t he number of hours you
49- 5000545 Rev. 1