PETLUX Premium PL-04 Manual De Usuario página 13

Using the sterilization function
When the device is in standby mode, take the sterilization accessory and attach it to the device
(as shown in the picture below). The cover will automatically click into place by means of the
magnetic contacts.
Then insert the DC plug into the OUT DC12V jack on the back of the bottom of the unit. The
device now switches to sterilization mode.
When the sterilization mode is running, you can see the UV light glowing slightly in a dark room
(don't look at the exposed UV light). The light will stop glowing after 15 minutes. Sterilization is
complete.
Then pair the sterilization accessory and unplug the plug from the OUT DC12V. After
disconnecting the sterilization accessory plug, the device switches off automatically and switches
to another mode.
Cleaning and maintenance
Cleaning the silicone mat:
When cleaning the silicone mat and other surfaces of the device, the device should be turned
off. You then wipe the dirty surface with a clean, soft, slightly damp cloth.
Note: There is a printed circuit board in the device. Make sure that no liquid gets in. Do
not put water in the device.
Sterilization - accessory
Handle
- 13 -