Publicidad
Ready To Use
Before Plugging the table into the outlet, make sure that
- The lift columns are level and set at the lowest position.
-
All the screws are tightened,to avoid the desk making noise and wobbling.
Activate the desk by following the next steps.
-Please press button down and hold for 10-15 seconds
until it stutters and beeps.
-Release the button, then your desk is ready to use.
Operation Guide
1. Memory desired height
-Press button "M",display show "S-" with flash.
-Press number and set desired position.
2. Advanced Safety feature- lock and
unlock the table.
-Press button up and down at same time for 5
seconds, display "LOC"
-All single button will be inactive and table
will be unable to move.
-Pressing button up and down together will
unlock the keypad and release the LOC
3. Reset the table
When display show Error code or RST,
Please reset the table.
-Unplug the power cord from the control box.
-Unplug the cable that links the keypad to the
control box.
-Wait 30 minutes and plug all the cables in again.
-Do the reset: please press button down and hold
for 10-15 seconds until it stutters and beeps.
If the keypad displays HOT,please unplug and replug
and let it cool off for a couple of minutes before proceeding again.
Desk Height
Up and Down
Setting three Memory Height
8
Press by holding
10-15 seconds
Publicidad
