Publicidad
Idiomas disponibles
Idiomas disponibles
14.4
When the faucet handle is closed in the vertical state (as shown in the "CLOSE"
position in Figure 12), pull the handle forward 45 degrees to press out the beer (as shown in
the "OPEN" position in Figure 12).
Before drinking beer, please rinse the glass with cold water. If the temperature of the glass is
very high, it will cause many bubbles. If the temperature of the beer is too high, it will cause a
lot of bubbles.
15.
When you press beer, please tilt the cup to the outlet of the faucet, then slowly make the
bottom of the cup and the wine outlet vertical, and quickly open the handle of the faucet. If the
handle is not completely opened, it will cause a lot of bubbles. It is best to press half a glass of
beer
first
The outlet of the beer cannot be soaked in the glass filled with beer, otherwise it will cause a
lot of bubbles. If you finish the operation, please turn off the tap handle.
16.
It is normal to have more bubbles when pouring the first 3 beers.
17.
This is normal that when the beer in the beer keg is used up, there will be a short jet from
the mouth of the tap. Release the handle of the tap and turn off the tap.
Note : All functions from display panel will work properly, except for the remaining volume of
beer which will be fixed when using a 5L beer keg (red circled part as figure below):
and
then
pause
FIGURE 12
for
a
while
FIGURE 11
before
pressing
again.
Publicidad
