Klarstein AMAZONIA 6 SECRET Manual De Instrucciones página 49

Important notes
• The salt container must only be refilled when the salt warning light in the control
panel comes on. Depending on how well the salt dissolves, the salt warning light
may still be on even though the salt container is filled.
• If there is no salt warning light in the control panel (for some Models), you can
estimate when to fill the salt into the softener by the cycles that the dishwasher has
run. If salt has spilled, run a soak or quick program to remove it.
Adjusting the salt consumption
1. Open the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the Program buttonfor
more than 5 seconds to enter the water softener setting mode.
3. Press the Program button again to select the proper set according to your
local environment. The setting will change in the following sequence:
H1>H2>H3>H4>H5>H6.
4. Press the Power button to end the setting mode.
Water hardness level
°dH mmol/l
1
0-5 0-0.9
6-1 1 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.1
35-45 6.2-8.0
¹ German degree of measurement for the water hardness
² International unit for water hardness
Factory setting
*
Note: Without any operation in five seconds, the machine will exit from set mode, the
machine is into standby status.
Setting on the
water softener
2
1
2
3
4
*
5
6
Digital Display stalls
H1
H2
H3
H4
H5
H6
EN
49