Publicidad
1. Power on the device and connect the Ethernet cable to your computer.
2. Allow the gateway to boot up. This might take up to 60 seconds.
3. To enter the gateway Web interface (WebUI), type
4. Use login information shown in image A when prompted for authentication.
5. After you log in, you will be prompted to change your password for security reasons. The new password must contain at least 8 characters,
including at least one uppercase letter, one lowercase letter and one digit. This step is mandatory, and you will not be able to interact with
the gateway WebUI until you change the password.
6. When you change the gateway password, the
gateway main operating parameters.
7. Go to the
Overview
page and pay attention to the
the antennas or changing the location of your device to achieve the best signal conditions.
A.
RF technologies
Max RF power
Power adapter
Mobile antenna
GNSS antenna
*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.
All manuals and user guides at all-guides.com
DEVICE CONFIGURATION
http://192.168.1.1
Configuration Wizard
Signal Strength
admin
admin01
TECHNICAL INFORMATION
Radio specifications
EGPRS, NB-IoT, LTE (Cat-M1), GNSS
33 dBm@GSM, 23 dBm@LTE
Bundled accessories specifications*
Input: 0.4 A@100-240 VAC, output: 9 VDC, 1 A, connected to 16 pin terminal block
698~960 / 1710~2690 MHz, 50 Ω, VSWR < 3, gain** 3 dBi, omnidirectional, SMA male connector
1575.42~1602 MHz, 2.2~5 VDC, VSWR < 1.5, gain** 28 dB (typ.), RHCP polarization, SMA male connector
into the URL field of your Internet browser.
will start. The
Configuration Wizard
indication (image B). To maximize the cellular performance try adjusting
B.
Data connection
State
SIM card slot in use
Bytes received/sent
is a tool used to set up some of the
-65 dBm
Connected
Registered (home); OPERATOR; 4G (LTE)
Ready
348.7 KB / 223.5 KB
Publicidad
