Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING INSTRUCTIONS
− This electrical water heater should be mounted on the solid cement walls.
Furthermore, the places where are close to the power source's sockets and
conveniently use the water.
Cautions: Please try to use our cornpany's fitted accessories to mount this electrical
water heater. After confirming the brackets to be firmly fixed for the reliabilities, then you
can hang on this electrical water heater. Otherwise, the electrical water heater may fall
down from the walls, and cause the severe damaging accidents.
− Before determining the bolt hole's position,
you should guarantee the right side of the
electrical water heater to be more than
200mm away the ground. This will be
convenient to leave out a certain space to
maintain when it is necessary.
− Assembling Method: After selecting the
proper positions well, use the fitted inflation
bolts to fix the hanging firm Cement Wall
board firmly, and then hang on the
PIPE CONNECTIONS
− Ali the pipe parts are G 1/2". Wind a certain raw material tape at the water-entering
mouth sector of the electrical water heater (Blue Sign Identification). Then re-install the
mono-directional security valve well.
− The remaining pipe's connection method can be referred to NO.7 figure (Diagram 6).
− If the user wants to offer the water by poly-routes, then you can refer to the No. 8 figure
for connecting the pipes (Diagram 7).
CAUTIONS
− The installed walls must be solid; the inflation bolts must be tau tly spun. And install it
firmly. Mustn't loosen and prohibit to mount it in the heart-emptied bricks or the brick
crevices.
− The power source's socket must be adopted the super-quality nono-plastic tri-pole one
.which complies with the state's gangs, and it must be fitted the qualified ground wire,
which must be installed at the properly high positions K and the uneasily water-
showered damp places. This outlet had better be typically used for the electrical water
heater (Diagram 8).
− When it is in the initiative operation, you must make the tank totally fill with water, after
that, you can put through the power sources.
All manuals and user guides at all-guides.com
-25-
Firm cement wall
Diagram 5
Inflation Bolt
Publicidad
