Descargar Imprimir esta página

Important Safeguards - DeLonghi HM24 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

radiatore 5710001600
19-01-2001 11:55

IMPORTANT SAFEGUARDS

When using electrical appliances, basic precautions should always be followed to reduce risk
of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. If your radiator is equipped with a polythene tape used as carry handle, remove it before
connecting appliance to the outlet.
3. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
Use handle when moving this heater. Keep combustible materials, such as furniture, pil-
lows, bedding, papers, clothes, and curtains at least 3 feet (0,9 m) from the front and top
of the heater and keep them away from the sides and rear.
4. Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
5. Always unplug heater when not in use.
6. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has
been dropped or damaged in any manner. If heater has leaked any oil, discontinue using the
heater and contact the service center as indicated in this instructions leaflet. Return heater
to authorized service facility for examination, electrical or mechanical adjustment, or repair.
7. Do not use outdoors.
8. This heater is not intended for use in bathrooms, laundry areas and similar indoor loca-
tions. Never locate heater where it may fall into a bathtub or other water container.
9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the
like. Arrange cord away from traffic area and where it will not be tripped over.
10. To disconnect heater, turn controls to off, then remove plug from outlet.
11. Connect to properly polarized outlets only.
12. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock, fire, or damage the heater.
13. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use
on soft surfaces, like a bed, where openings may become blocked.
14. A heater has hot or arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
15. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
16. To prevent overload and blown fuses, be sure that no other appliance is plugged into the
same outlet (receptacle) or into anolher outlet (receptacle) wired into the same circuit.
17. It is normal for the heater's plug and cord to feel warm to the touch. A plug or cord which beco-
mes hot to the touch or becomes distorted in shape may be a result of a worn electrical outlet.
Worn outlets or receptacles should be replaced prior to further use of the heater. Plugging
heater into a worn outlet /receptacle/ may result in overheating of the power cord or fire.
18. Do not use an extension cord because the extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the cord shall be No. 1 4 AWG minimum size and
rated not less than 1875 watts, and has to be used only for supplying power to this heater.
19. Be sure that the plug is fully inserted into an appropriate receptacle. Please remember that recepta-
cles also deteriorate due to aging and continuous use: check periodically if signs overheating or
deformations are evidenced by the plug. Do not use the receptacle and CALL your electrician.
20. Check that neither the appliance nor the power cable have been damaged in any way
during transportation.
21. Make sure that no pieces of polystyrene or other packaging material have been left
between one element of the appliance and another. It may be necessary to pass over the
appliance with a vacuum cleaner.
22. When switching on the appliance for the first time, allow it to run at full power for
about two hours to get rid of the unpleasant smell. Make sure that the room in which
the appliance is located is well ventilated during this operation. It is normal for the
appliance to emit small cracking sounds when you turn it on for the first time.
CAUTION: To prevent electric shock match wide blade of plug to wide slot, fully insert.
SAVE THESE INSTRUCTIONS
2
All manuals and user guides at all-guides.com
Pagina 2

Publicidad

loading