Operation - Senix LSPG-M3 Manual Del Operador

Blade Control
Recoil Starter Handle
Rope Guide
Recoil Starter
Handle Connecting Knob
BLADE CONTROL
The blade control is attached to the upper handle of the mower. Depress and hold
against the upper handle to operate. Release it to stop the engine and blade.
WARNING
This blade control is a safety device. Never attempt to bypass its operation.
SIDE DISCHARGE COVER
Your mower is shipped as a mulcher. To discharge the grass clippings to the side
instead, follow the instructions in the assembly section to attach the side discharge
cover.
WARNING
Keep hands and feet away from the chute area on cutting deck. Refer to warning
label on the unit.
MULCHING COVER
The mulching cover is used for mulching purposes. Instead of collecting the grass
clippings in a grass catcher or using the side discharge chute, some mower models
have the option of recirculating the clippings back to the lawn. This is called
mulching. Close the mulching cover when mulching so that the clipped grass can
not discharge from side.
10

OPERATION

Upper Handle
Lower Handle
Cutting Height Adjustment Lever
Rear Wheel
Oil Tank Cap
Fuel Tank Cap
Primer
Cable Clamp
Handle Fixing Knob
Side Discharge Cover
Mulching Cover
CUTTING HEIGHT ADJUSTMENT LEVER
This product is designed with dual-lever height adjustment. The height of
front wheel and rear wheel can be respectively adjusted by two cutting height
adjustment levers which locate above the front wheel and rear wheel. 6 cutting
heights (from 1.25inch to 3.75inch) are available. To adjust the cutting height, refer
to the assembly section.
RECOIL STARTER
The recoil starter is attached to the right upper handle. Depress and hold the blade
control handle, then pull the recoil starter rope to start the unit.
PRIMER
The primer is located on the left side of the engine. The primer is used to pump gas
into the carburetor and aid in starting the engine.
Front Wheel
WWW.SENIXTOOLS.COM