Publicidad
Idiomas disponibles
Idiomas disponibles
1 motor off, spark plug cable disconnected, fuel supply shut
2
The shredder must only be transported in a trailer.
Use appropriate loading ramps.
Tie the shredder down correctly using straps.
To unload, follow these instructions in reverse.
(to be done by your approved repairer) (To wear gloves)
- Disconnect the spark plug cable
- Open the obstruction clearance hatch (see VI –e)
- Remove the feeding chute (see VII)
- Using a 5 mm Allen key and a 13 mm open ended spanner, unscrew the 4 screws
(1) and nuts (2) holding the 2 blades in place (3).
- To sharpen (see diagram 1) or always replace the 2 knives at the same time. To
always replace screws and nuts during replacement or sharpening (see dia-
gram 1) of knives. (Caution only knives as well as fastening screws specifi-
cally designed for your crusher must be used.)
- To reassemble knives by taking care not to forget to restore the balance weight (4)
(Torque 24 N.m) To correctly align and stick the 2 knives one against the other.
VIII / TRANSPORT
Do not lift the shredder
IX / TO SHARPEN OR CHANGE KNIVES
2
4
3
1
13 - EN
Tie-down points
for trailer transport
Diagram 1
To respect the wedge angles
If side mini C less than 36 mm, it is
compulsory to replace the knives.
Risk of your machine deteriorating.
(Rotor Imbalance)
Publicidad
