General Operation - auna Radio Gaga 2.0 Manual De Instrucciones

All manuals and user guides at all-guides.com

GENERAL OPERATION

Starting Up Your Internet Radio
• Plug the adaptor connector into the DC Power Jack," Welcome" will be
shown on the screen. Ensure the antenna is extended as far as possible.
This will enable you to get the best signal you can.
• After the Welcome screen, if this is the first time of using your radio, you
will be able to select the language by scrolling with the Volume Knob
and confirm your selection by pressing down the OK button.
• After language setting, the screen will display "Enable Check Network
When Power On?".You can choose "YES" or " NO" to decide whether the
unit check network when power on or not.
Manual WIFI Set-up
After the above setting,the screen will show "Would you like to configure
Network now?".
• If you select "YES", your radio will begin to scan for nearby networks to
connect to. After scanning, you need to choose the network you want
to connect .Then type letters/numbers by scrolling with the Vloume
Knob or pressing the NUMBER/LETTER buttons until the correct digit is
displayed and click the RIGHT button to go to the next digit.
• Once finished, press down the OK button to confirm.
• If you select "NO" then you can set this up later in configuration
settings.
Wireless Network (WPS PBC)
When at the "Would you like to configure network now?" stage, if you select
"YES(WPS)" your radio will begin to search for WiFi connections.
While this has been selected, you will have 120 seconds to click the WPS
button on your WiFi modem. This will connect your WiFi to your radio
without manually writing in the passcode.
Complete WIFI Connection
Once your WIFI is completed by manually entering your WIFI password pr
via WPS, you will be taken to the main menu screen and the WIFI signal will
appear in white at the top left. Your internet radio is now set up.
EN
31