Publicidad
Idiomas disponibles
Idiomas disponibles
■
Follow the instructions regarding the
requirements for the place of instal-
lation and on the unit's electrical con-
nection to prevent personal harm and
property damage.
■
Never touch rotating parts of the unit.
■
Never put objects or body parts in the
unit while it is running.
■
Never leave the unit unsupervised dur-
ing operation.
■
Fill the unit only up to the respec-
tive mark. If overfilled, hot liquid can
emerge from the tank.
unpacking
To unpack the unit, proceed as below:
■
Take the unit out of the carton.
■
Remove all pieces of the packing.
■
Remove any possibly extant labels from
the unit (do not remove the rating
plate).
requirements for the installation
location
For safe and flawless operation of the
unit, the place of location must meet
these prerequisites:
■
The unit must be set up on a firm, flat,
level, non-slip and heat resistant base
that has sufficient load bearing capac-
ity.
■
Select the place of location so that chil-
dren cannot reach the hot surfaces of
the unit.
■
The unit is not intended for installation
in a wall or a built-in cupboard.
■
Do not set up the unit in a hot, wet or
moist environment.
■
The electric socket must be readily ac-
cessible so that the power cord can be
easily unplugged.
Electric connection
Follow these instructions about the
electrical connection for safe and flaw-
less operation of the unit:
All manuals and user guides at all-guides.com
■
■
■
■
■
■
■
■
■
■
© Gebr. Graef GmbH & Co. KG
Before connecting the unit, compare
the connection information (voltage
and frequency) on the rating plate with
those of your electrical network. This
information must match to avoid dam-
age to the unit. If in doubt, ask your
electrician.
The socket must be fused with at least
a 10A circuit breaker.
Make sure that the power cord is not
damaged. Do not conduct it over hot
surfaces or sharp edges.
The connector cable must not be pulled
tight.
The electrical safety of the unit is only
ensured if it is connected to a prop-
erly installed protective conductor
system. Operation on a socket with-
out a protective conductor is prohib-
ited. If in doubt, have the building
installation checked by an electrician.
The manufacturer does not assume any
responsibility for damages caused by a
missing or interrupted protective con-
ductor.
Electric connection
Follow these instructions about the
electrical connection for safe and flaw-
less operation of the unit:
Before connecting the unit, compare
the connection information (voltage
and frequency) on the rating plate with
those of your electrical network. This
information must match to avoid dam-
age to the unit. If in doubt, ask your
electrician.
The socket must be fused with at least
a 10A circuit breaker.
Make sure that the power cord is not
damaged. Do not conduct it over hot
surfaces or sharp edges.
The connector cable must not be pulled
tight.
The electrical safety of the unit is only
ensured if it is connected to a prop-
EN
9
Publicidad
