Publicidad
Idiomas disponibles
Idiomas disponibles
When using electrical appliances, basic safety precautions should be followed:
1. Read all instructions carefully.
2. Make sure the power supply corresponds to one on the rating label.
3. To avoid electrical shock, do not immerse electrical parts in water or other liquid.
4. Do not allow children to operate or play with the appliance.
5. Unplug from outlet when not in use, or before putting on/taking off parts.
6. Do not use with damaged electrical cord or plug.
7. If damaged or malfunction occur, refer to an authorized service center only.
8. Never pull the appliance by power cord.
9. Do not use the appliance for other than intended household use.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, unless they have been given supervision or instruction by a
person who is responsible for their safety concerning the use of the appliance. Children should be supervised
to ensure that they do not play with the appliance.
Fan Function:
1. Turn the controller to "FAN". The fan will blow out air at room temperature
2. If the fan does not operate, the ambient room temperature is cooler than the built-in thermostat "OFF"
level. Turn the thermostat dial gradually clockwise and the fan will start blowing.
3. As soon as the fan starts, the light in the front of the machine will illuminate.
Heating Function:
1. Turn the control dial to "I" for low heat and "II" for full heat.
2. Set the level of heat by turning the thermostat dial gradually clockwise for the lowest heat and fully
clockwise for maximum.
3. The thermostat will turn the machine off when the selected room heating is achieved, and when the
temperature drops it will turn on again automatically.
4. For maximum heat output use "II" with the thermostat turned fully clockwise.
5. To distribute heat evenly around a room, press "SWING" button.
Overheating:
1. The thermostat will turn the machine off it overheats.
2. Overheating can be caused by obstruction to the air intakes on the back of the machine or the grill on the
front .If this occurs please disconnect the machine and allow it to cool for 30 minutes. Remove any
obstruction and turn the machine back on.
3. If the heater ceases to function, the most likely cause is a blown fuse. Simply replace the 13amp fuse in the
plug and reconnect. If there is still no function please follow the repair advice above.
Warning:
VDE Plug
This appliance is equipped with a grounded, power supply cord. This is a safety feature. Do not attempt to
defeat the safety purpose of this plug.
All manuals and user guides at all-guides.com
IMPORTANT SAFEGUARDS
- 2 -
ENGLISH
Publicidad
