Mounting The Microphone - Shure WL50 Guia Del Usuario

All manuals and user guides at all-guides.com
USING THE MC50/MC51 WITH A MIXER
The preamplifier supplied with both the MC50 and MC51 requires phantom power ranging from 11 to 52 Vdc. Connect
the preamplifier to a mixer input with a minimum load impedance of 800 Ω to maximize operating headroom.
USING THE WL50/WL51 WITH OTHER BODYPACK TRANSMITTERS
If connecting the WL50/WL51 to anything OTHER than a Shure wireless bodypack, make sure the device provides a
regulated +5 Vdc (130 mA minimum) to the red conductor. Refer to the wiring diagrams in Figures 3 and 4 on page 14.
WIRING THE WL50X/WL51X TO AN ALTERNATE CONNECTOR
Model WL50X/WL51X is supplied with a stripped and tinned cable for wiring to a variety of connectors. Refer to the
WL50X/WL51X wiring diagram in Figure 4 on page 14. For additional information on wiring the WL50X/WL51X to an alter-
nate connector, contact Shure's Applications Department at (847) 866–2525 or 1–800–516–2525.

MOUNTING THE MICROPHONE

The WL50/WL51 and MC50/MC51 microphones come with the following mounting accessories
(see Figure 5 on page 15):
Swiveling Lapel Clip. Features a spring-loaded clasp that attaches easily to a necktie, lapel, blouse or shirt, connected
to a rotatable mounting clip. To mount, snap the microphone cable into the clip near the neck of the microphone, then
attach the clasp to an article of clothing. Rotate the mounting clip to place the microphone at desired angle.
5