Removing The Battery Pack From The Machine; Operating Tips - Toro Super Recycler Manual Del Operador

Removing the Grass Bag
DANGER
The machine can throw grass clippings and other objects through an opening in the machine
housing. Objects thrown with enough force could cause serious personal injury or death to
you or to bystanders.
• Never remove the grass bag and then start the machine without the discharge plug installed
on the machine.
• Never open the rear deflector on the machine when the machine is running.
1. Shut off the machine and wait for all moving parts to stop.
2. Raise the rear deflector.
3. Remove the bag rod on the grass bag from the notches at the base of the handle (A of
4. Install the discharge plug (B of
5. Lower the rear deflector (C of
Removing the Battery Pack
from the Machine
1. Lift up the battery-compartment lid.
2. Press the battery-pack latch to release the
battery pack and remove the battery pack.
3. Close the battery-compartment lid.

Operating Tips

General Mowing Tips
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
For best performance, install a new blade before
the cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
For improved runtime, cut grass at a higher height
of cut.
•
Do not cut below 51 mm (2 inches) unless the
grass is sparse or it is late fall when grass growth
begins to slow down.
•
When cutting grass over 15 cm (6 inches) tall,
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the
best lawn appearance. If the grass is too long, the
machine may plug and cause the motor to stall.
•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the motor to
stall. Avoid mowing in wet conditions.
Figure 20).
Figure 20).
•
•
•
Cutting Leaves
•
•
•
24
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the machine free of dry grass and leaf debris.
Alternate the mowing direction. This helps
disperse the clippings over the lawn for even
fertilization.
If the finished lawn appearance is unsatisfactory,
try 1 or more of the following:
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than a single pass over the leaves.
If there are more than 13 cm (5 inches) of leaves
on the lawn, mow at a higher cutting height and
then again at the desired cutting height.
Slow down your mowing speed if the machine
does not cut the leaves finely enough.
Figure 20).