Bimar SHL215 Folleto De Instrucciones página 10

All manuals and user guides at all-guides.com
Fax +32 030 9904733
• In case of breakdown or malfunction or if the cord or plug are damaged, turn off the unit and have
it checked by a qualified professional; repairs carried out by unqualified personnel can be
dangerous and invalidate the warranty.
ASSEMBLY
Warning: before assembling the appliance, make sure it is disconnected from the power point
•
Place main unit (7) on a horizontal supporting surface that is stable and washable.
•
Place the collector (4) onto the main unit, so that the nozzle pokes out from the hole.
•
Insert the sieve into the collector and engage its base properly with motor disk.
•
Place the cover onto the main unit, making sure that the three pins and slots meet.
•
Place the pulp container (6) into its place.
•
Place a glass under the spout (8) to collect the juice (not supplied).
USE
Before each use, check that the equipment is in good condition, that the wiring is not damaged: if the
power cable is damaged, it must be replaced by the manufacturer or its technical assistance centre or
by someone who is similarly qualified, in order to prevent any risks.
The appliance is equipped with:
- Switch 0-I: with the button set to "I", the unit turns on; with the button in the "0" position, the
power is off (pos. 0). The switch lever only works if the lid is correctly placed on the main
unit.
- Presser for inserting the food to be juiced
- Pulp container
•
Plug into the power point.
•
Move the switch cursor to pos. I to operate the centrifuge.
•
Make sure the container pulp is correctly placed and that there is a glass for the juice under the
spout.
•
Insert the food via the hole in the lid and press it gently but firmly with the presser supplied.
Avoid putting too much food at one time.
•
The appliance can operate continuously for up to two minutes, after which requires a break of at
least 2 minutes before using it again. Failure to do this may affect the performance of the
appliance. The centrifuge is equipped with a thermal safety device which stops operation in case
of overheating. To restore operation wait until it cools. Where the appliance blocks during use,
switch off, unplug from the power point and remove all accessories for cleaning.
•
Empty the pulp container when full.
•
The glass used to collect the juice, once completely filled and finished after use, should be left for
a moment below the spout to collect the drippings.
•
When in use, the appliance must be continuously checked in order to allow the user to intervene
should events occur that could compromise safety.
•
Once you have finished using the appliance, turn it off by turning the cursor to pos. 0, then unplug
the device from the socket.
When juicing dryer foods, you can add a bit of water through the conduit of the lid in order to extract
the juice properly from the pulp.
You can remove most of the residues inside the jug, by slowly inserting water through the conduit:
make sure the pulp container and glass are empty in order to collect the liquid created.
If the appliance is not in use for long periods of time, remove the plug from the plug point.
Practical advice
The centrifugal juicer is suitable for celery, spinach, carrots, apples, bananas, oranges, lemons,
melons, tomatoes, cucumbers and all kinds of fruits and vegetables that contain juice, while it is not
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
10/32
Assembly page 10/30