ledscom LC-EL-082 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
Remove the lamp (1) from the mounting
pot (2).
Guide the power supply side connection
cable (3) through the opening on the
underside of the mounting pot (2) and
place it in its mounting position.
4. Open the light (1) by loosening the four
screws (4) on the top of the light. Then
carefully lay the frame (5), the washer (6)
and the sealing ring (7) aside so that they
cannot be damaged.
5. Insert the lamp with the aid of the
clamping spring.
6. Connect the connection cable (12) of
the light to the connection cable (3) on the
power supply side. To do this, tighten the
screw seal hand-tight.
Now place the lamp (1) in the mounting pot
and fix it in place using the screws (10)
supplied.
Now align the lamp head (11).
9. Close the housing and retighten the four
screws (4).
0. 1Switch the power supply back on. The
installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Ground recessed light (LC-EL-082) - Assembly instructions
Figure 1
Figure 2
04/2022