Publicidad
Idiomas disponibles
Idiomas disponibles
Program the Operation Schedule
PERIOD 2
STEP 1 - START time:
Press the UP or DOWN arrows to Adjust Hours.
Press the ENTER button once.
Press the UP or DOWN arrows to Adjust Minutes.
STEP 2 - END time: Press ENTER button once.
Press the UP or DOWN arrows to Adjust Hours.
Press the ENTER button once.
Press the UP or DOWN arrows to Adjust Minutes.
PERIOD 3
If you want to set Period 3, and the display shows "3/OFF", you need to enable Period 3 by pressing the UP arrow once.
:
To turn Period 3 OFF again, press either the UP or DOWN Arrow during STEP 1 (when HOURS is flashing) until the display shows "3/OFF".
NOTICE
Set the Current Time
Press the MENU button and hold it.
> HOURS will start to flash.
Stop pressing MENU.
Press the UP or DOWN arrows to Adjust Hours.
Press the ENTER button once.
> MINUTES will start to flash.
Press the UP or DOWN arrows to Adjust Minutes.
Press the ENTER button.
> Control Panel will display Period 1 settings.
PERIOD 1
STEP 1 - START time:
Press the UP or DOWN arrows to Adjust Hours.
Press the ENTER button once.
Press the UP or DOWN arrows to Adjust Minutes.
STEP 2 - END time: Press ENTER button once.
Press the UP or DOWN arrows to Adjust Hours.
Press the ENTER button once.
Press the UP or DOWN arrows to Adjust Minutes.
STEP 3 - Operating Speed: Press ENTER button once
Press either LOW, MEDIUM or HIGH.
Adjust the Operating Speed in 25 RPM increments by
pressing the UP or DOWN Arrows.
STEP 4 – Press the ENTER button once, the Control Panel will display
Period 2 settings.
STEP 3 - Operating Speed: Press ENTER button once.
Press either LOW, MEDIUM or HIGH.
Adjust the Operating Speed in 25 RPM increments by
pressing the UP or DOWN Arrows.
STEP 4 – Press the ENTER button once, the Control Panel will display
Period 3 settings.
If you are only setting Periods 1 and 2, wait 7 to 10
seconds and the new settings will be saved.
Then skip to the directions on the following page for "Start
Automatic Mode."
Publicidad
