Preparation; Preparing The Setup Location And The Connections; Installation; Assembling The Solar Shower - Steinbach Pool Professional The Gate Manual Original

The solar shower has a cold water supply line leading directly to the faucet
adjusted to the perfect temperature for showering.
The illustration shows how a solar shower works:
The entire shower body is filled with water and
works in a similar way to an electric water heater
in which the heated water also collects at the top.
If hot water is needed, the faucet
the tank is turned to let in cold water and the
5
water in the top region, which has already been
heated, is pushed out of the tank.
Any pressure that builds up due to the water
heating up in the tank can therefore escape
through the shower head
drip from the shower head when the faucet is
closed.

Preparation

Preparing the setup location and the connections

The safest place to use the shower is on a smooth, level concrete or wooden floor.
Careful selection and good preparation of the setup location makes it much easier to set up and use the
shower. The following requirements must be met or considered:
- Water supply and drain pipes, direct sunlight
- Stable, level, anti-slip surface that is resistant to water

Installation

The product can topple.
- A second person who holds the product is required for installation.

Assembling the solar shower

To assemble the solar shower, proceed as follows:
1. Position the frame
correct direction.
2
12
16
at the base of
4
. This causes water to
1
Risk of injury!
at the prepared location. Make sure that the solar shower is pointing in the
7
5
6
7
1
5
CAUTION!
3
so that the water can be
4
1
9
1
4